HYCO IN96T Aquila Instantaneous Inline Water Heater 9.6 kW

Outer Casing Easy clean high impact ABS Heating Element Bare-wire heating system (2 nickel chrome heating elements) Control Screen (from left to right) Temperature display (°C).Actual flow rate display (l/m)Heating power display (%)Memory – save selected temperature.Touch screen arrow keys allow the user to set the required temperature.Touch screen power on/off control.The temperature display will flash if the set temperature cannot be reached. Flow Dial Increase/decrease maximum water flow rate. Safety Overheat temperature protection 75°C (manual reset). Water temperature electronically controlled to maintain user selected temperature between 30°C and 60°C as water pressure conditions vary. IP Rating IPX4 Installation This appliance must be installed in a frost free environment.The heater should be located as close as practical to the hot water outlet to avoid unnecessary heat losses through the pipework. PlumbingMust be installed by a suitably qualified person. Minimum flow rate 2.5 l/m. Minimum water pressure 1 bar. Maximum water pressure 7.5 bar. Water resistivity ≥ 1300 Ωcm.  Water ConnectionInlet/Outlet 2 x 1/2″ BSP male (100mm apart centre to centre).Fittings required (not supplied): 2 x 15mm compression to 1/2″ BSP female adapter.Suitable for use with pre-heated water e.g. solar heating systems subject to maximum inlet water temperature 60°C. Electrical Connection Installation must comply with current IEE regulations. Single phase, fuse rating guide 42 amps. The product should be connected to the fixed wiring of the property via suitably rated isolating switch with a contact separation of at least 3mm in all poles. Approvals CE, WRAS Standard Warranty 1 year parts or replacement warranty.