Full Width Carbon Fibre Insole Plate

Description These Full Width Carbon Fibre Insole Plates are useful for people who have a problem with the big toe joint of their feet that would benefit from restricting the range of the motion of the joint. These include disorders such as hallux rigidus, hallux limitus, osteoarthritis or turf toe and related conditions. The smaller kids sizes can be used for idiopathic toe walking. These flat rigid insoles are only 1.2mm thick and are very rigid. If you need the Morton’s Extension version rather than these full-width inserts, we have the Morton’s Extension Carbon Fibre Insole Plates available. See our article on ‘Full width or Morton’s Extension for a rigid carbon plate in the shoe?‘ to help decide which one will most likely meet your needs. These are sold as singles, so if you need them for both feet, then order two. There is no left or right as they are just turned up the other way for the other foot. These Full Width Carbon Fibre Insole Plates are sold in millimetres and we have 20 sizes available. To determine your size, remove an insole from any of your current shoes and measure the length. Order that size. See our articles on: Hallux rigidus insoles Turf toe inserts Full width or Morton’s Extension for a rigid carbon plate in the shoe? Treatment of Freiberg’s disease with rigid foot plates How do the shoe stiffening inserts work? Frequently asked questions about the Full Width Carbon Fibre Insole Plate: How long does shipping take? We ship every day. Most orders are sent the day we get them. However, we are at the mercy of Australia Post or the different couriers that we use after that. This can vary from a few days up to a week or so and obviously more during the festive season. We do try our best to get them to you as quickly as possible. Do the inserts come in a left or right? No. The carbon fibre inserts are interchangable. You simply turn them up the other way for the other foot. How comfortable are the ‘Full Width Carbon Fibre Insole Plates’ to wear? They are “ok”. The inserts are rigid and are designed to restrict motion across the joints in the front of the foot. This means that they will change the way you walk, so that may take some getting used to them, so go slowly initially. They may be uncomfortable to start with as you get used to them, but they should give relief from the pain that you are feeling due to their ability to restrict that motion. What shoes should they be worn in? They can not be worn in shoes that have anything more than 1-2cm heel height as the plates are rigid and are not flexible. Shoes that are firm or have a rocker type sole are best. How to determine which size to order? This inserts are measured in millimetres (mm). We suggest that you use an insole from your shoes and measure the length of that and order 10-15mm shorter than that to allow for shoe fit.. Err slightly on the shorter side if you are unsure. Can these rigid insole be adjusted in the length? No. Sometimes when you measure the size that you need, you might not fit exactly to the lengths that we have available. In those cases order the smaller one. A small gap at the front of the insert in the shoe is usually not noticed. These inserts are almost impossible to modify with scissors or anything like that as they are very rigid. If you have access to some type of grinder, it will be possible to reduce some length off them. BUT, do so carefully.