HYCO IN44T Rho Thermostatic Instantaneous Inline Water Heater 4.4kW

Outer CasingEasy clean high impact ABS Heating ElementBare-wire heating system (3 nickel chrome heating elements) Controls (Thermostatic Model only)Temperature display (°C)Power on/off button /- controls allow the user to set the required temperatureThe temperature display will flash if the set temperature cannot be reached. Taps and Tap Spray NozzlesIntended for use with spray head taps with removable M22/M24 nozzles. Important – the supplied tap spray nozzle must be fitted in the tap for best performance. 4.4 kW: 2.0 l/m, 6.0 kW: 2.5 l/m, other flow rates available on request. SafetyOverheat temperature protection 80°C.Thermostatic model – water temperature controlled to maintain user selected temperature between 30°C and 48°C as water pressure conditions vary. IP RatingIPX4 InstallationThis appliance must be installed in a frost free environment. The heater should be located as close as practical to the hot water outlet to avoid unnecessary heat losses through the pipework. PlumbingMust be installed by a suitably qualified person. Minimum flow rate 2.0 l/m. Minimum water pressure 1 bar. Maximum rated pressure 7.5 bar. Water resistivity ≥ 1300 Ωcm. Water ConnectionInlet/Outlet 2 x 1/2″ BSP male (40mm apart centre to centre).Fittings required (not supplied): 2 x 15mm compression to 1/2″ BSP female adapter. Suitable for use with pre-heated water e.g. solar heating systems subject to maximum inlet water temperature 60°C. Electrical ConnectionInstallation must comply with current IEE regulations.Single phase. Fuse rating guide 19 amps for 4.4 kW and 27 amps for 6.0 kW. The product should be connected to the fixed wiring of the property via a suitably rated isolating switch with contact separation of at least 3mm in all poles.Cable pre-wired (0.7m). ApprovalsCE, WRAS Standard Warranty1 year parts or replacement warranty.